Carbon Dioxide Gas Detector SMART3-R S3973CO2Carbon Dioxide Gas Detector SMART3-R S3971CO2
Back to: Gas detectors for non classified area
S3972CO2 Détecteur de Gaz Dioxyde de Carbone, CO2, Carbon Dioxide Gas DetectorS3972CO2 Détecteur de Gaz Dioxyde de Carbone, CO2, Carbon Dioxide Gas Detector

Carbon Dioxide Gas Detector SMART3-R S3972CO2

Carbon Dioxide Gas Detector, CO2 Gas Detector 0-20% Vol 4-20mA - Infrared sensor - SMART3-R for non classified area S3972CO2 Sensitron

S3972CO2 - CARBON DIOXIDE Gas Detector (CO2) 0-20% Vol, 4-20mA - Infrared sensor - SMART3-R

S3972CO2 SMART3-R gas detectors are employed to detect Carbon Dioxide, CO2 Gas compounds (%Vol) in non classified areas.

The SMART3-R (with LEDs indication) gas detectors are ideal for non-classified areas.
They employ high quality catalytic, MOS sensors, electrochemical cells or infrared sensors, that grant an excellent linearity and accuracy, besides an estimated lifetime of four years for detectors with infrared or pellistors sensors and two years for electrochemical cell sensors.

The SMART3-R gas detectors provide a proportional 4-20mA output signal. By employing optional boards, they can either communicate on a serial bus RS 485 or provide relay outputs.
In details, the available outputs are as follows:
• 4-20 mA. Proportional 4-20mA output current corresponding to the full range (LEL or ppm).
• Relay. By adding the STS3REL board, the unit is provided with 3 relays with voltage free changeover contacts. One relay is dedicated to the Fault and Watch-dog, while the remaining two relays can be associated to two out of the three available alarm thresholds.
• Serial RS485. By adding the STS.IDI interface, the detector can communicate on RS485 bus with MULTISCAN++ gas control panels.

It is available also as 220V Standalone version with 3 relays card.

The SMART3-R detectors employ a powerful microprocessor that provides the following built-in features:
Self-diagnostic procedures to control the hardware and sensor correct operation.
Zero follower to maintain the detector zero point, from possible drifts caused by thermal or physical variations of the transducer.
Digital filter, employed in the digital analysis of the analog values sampled, this filter corrects temporary phenomena from causing reading errors or false alarms.
Hysteresis cycle: applied to the outputs associated to the alarm thresholds, it prevents continuous output switching when close to the threshold values.

The SMART3-R detectors offer a fast and failsafe installation as well as an easy maintenance and calibration routine via the handheld keypad STS/CKD.

The SMART3-R gas detectors run with a power supply at 12-24Vd or 220V and are available in IP54 rated enclosure and they have an integrated buzzer.



Gas Detector type : Carbon Dioxide Gas Detector, CO2 Gas Detector