Reflective Optical Beam Detector FR5000

FR5000 - Motorised Reflective Optical Beam Smoke Detector

The FIRERAY 5000 motorised reflective, auto aligning infrared optical beam smoke detector can be installed with up to four detector heads per system, thus saving on installation time and costs.This innovative system has been designed from the ground up to include pioneering technology that fully addresses the needs of the installer and user, both now and in the future.
With its industry leading optics, the FIRERAY 5000 is ideally suited for the protection of large areas where the use of traditional detection technologies would prove to be too difficult and/or costly to install.
The FIRERAY 5000 combines an infrared transmitter and receiver in the same discrete unit and operates by projecting a well-defined beam to a reflective prism, which returns the beam to the receiver for analysis. Smoke in the beam path causes a drop in power, which, if below a pre-determined level, results in an alarm signal.

FEATURES & BENEFITS

- Up to 4 Detectors per System Controller
- Each Detector configurable from 8m to 100m
- Integral LASER
- Auto-Align Fast Automatic Beam Alignment
- Building Movement and Contamination Compensation
- Low Level System Controller
- 20mm Cable Gland Knockouts on System Controller
- 2-wire interface from System Controller to Detector
- 5 yearWarranty

Listings

UL - S3417
ULC - S3417
MEA - 22-08-E
CSFM - 7260-1508-104
FM Approved
Maryland - 2243

TECHNICAL SPECIFICATIONS

• Housing: Flame Retardant ABS
• IP Rating: IP54
• Finish: Light Grey/Black
• Knock Outs: Controller: 7-1/2/M-20
• Detector Head: 1-
• Weight: Head & Controller 3.24 lbs (1.47 kg)
• Dimensions: Head: 5.28 H x 5.31 L x 5.28W (135mm H x 134mm L x 132mmW)
• Dimensions: Controller: 3.20 H x 9.25 L x 7.87W (81mm H x 235mm L x 200mmW)
• Dimensions: Prism: 0.37 H x 4.13 L x 3.94W (9.5mm H x 105mm L x 100mmW)
• Primary Input Power: 14 to 28VDC
• Standby Current: Low Current Mode: 10mA to 16mA @24VDC depending on number of detector heads used
• Standby Current: High Current Mode: 50mA @24VDC
• Alarm Current: 10mA to 16mA @ 24VDC depending on number of detector heads used
• Relay Contacts: 1A at 30VDC Resistive
• Reset Time: 5 Seconds maximum
• Start Up Time: 45 Seconds
• OpticalWavelength: 850nm
• Alarm Threshold: 10% - 60% (35% Default)
• Temperature Rating: -4©F to 131©F (-20°C to 55°C) For UL Listed Installations: 32©F to 100©F (0°C to 38°C)
• Relative Humidity: 0% to 93% RH non-condensing
• Range: 26.25ft. to 330ft. (8m to 100m)
• Cabling Between each Detector & Controller: 18-14 AWG 1-Pair Shielded

-