Flame Simulator for IR3 and Multi IR FS-1100

FS-1100 - Flame Simulator for all IR3 and Multi IR Flame detector - Spectrex

Providing foolproof, full loop testing of your fire detection system and up to 33% increase in testing distance to 12m

To be fully secure against fire, flame detector self-testing is not enough.
According to most local jurisdictional authorities you need to make sure that your entire fire detection system is fully intact. That means performing a full system loop test from the detector, through the controller, and up to the actual alarm notification. The only way to do so without lighting a fire is with an external flame simulator.
The FS-1100 Fire Simulator is the essential complimentary tool to the self-testing capabilities of your SharpEye™ IR3 Flame Detectors. It gives you the ability to fully test the perational readiness of your fire detection system, bringing fire prevention safety to a higher level.

In addition to verifying the flame detector’s viewing window cleanliness and its internal electronic operation, the FS-1100 Flame Simulator performs essential end-to-end
testing of the “full system loop”. It does this by simulating a fire that actually triggers the detector.

FEATURES & BENEFITS

• ATEX/IECEx approved for use in hazardous areas
• Long-range flame detector activation – from distances of up to 40ft (12m) – a 33% increase compared to previous simulator models
• Highly portable
• Creates easy access for testing detectors in hard to reach places, without the need for scaffolding
• Powered by rechargeable lithium-ion battery
• Operates for at least 1,000 tests without recharging
• Easy aiming using laser diode